Re-covering an old lounge- part three- the arms

As predicted, the lounge recovering is going slowly. This weekend I managed to cover the arms of one armchair. I don’t mind taking my time with the job though, I am learning so much along the way. The fact that the whole pile of work-in-progress is sitting in everyone’s way is annoying, but we are coping with a minimum of snarky comments and stubbed toes.

The inside arm covering was not without it’s challenges. There was a broken piece of frame to be fixed and a lot of tucking and stapling to do…

This is the broken arm support. We just screwed a piece of 2 X 1 pine over the top of it and it held well.
The first arm all stripped down to the foam.
First I covered the arm with some new cotton batting.
Then cut a big rectangle of the fabric and started tucking and cutting little slits before stapling it all in place.
The front of the arm really needs some help. I think I will have to untack it and trim the cotton wadding back a bit to reduce the puckering.

I do love the wheat colour of the fabric, but I am learning that I have to go very slowly on this project or I make silly mistakes like putting the wadding too far forward over the front of the arm. Oh well… on to the inside back next.

Leave a Reply